Installation & Service Manual
195
Camera Control with Ethernet Tally Configuration
7 Open the hosts file in Notepad and follow the Microsoft instructions to add the
following entries:
192.168.200.200 local host
192.168.200.200 <Summit/Solo Computer Name>
192.168.0.175 <Menu Computer Name>
<Additional Menu IP> <Menu Computer Name>
Note: The default Menu Panel IP Address is shown in this example.
8 Save the file.
9 Open the Embedded Security Manager and click
Leave in the Embedded Controls
pane.
10 Restart the computer, verify that the Current Status is “Enabled” in the of the
Embedded Security Manager.
Camera Control with Ethernet Tally Configuration
The GV K-Frame XP system uses Ethernet to communicate with the LDK Connect Gateway.
Some basic configuration is required in the Eng Setup menu.
To Next Page
Loading...
