External Interfaces
276
Create an External Device Definition
Create an External Device Definition
1 Touch Eng Setup, Ports & Devices, External Devices to go to the External Device
Definition menu.
2 Scroll through the list of devices on the left and select an available device.
3 Select
Device Name and enter a descriptive name for the External Device.
4 Choose the control protocol for that device from the Type list.
• If an Ethernet protocol was selected, enter the IP address for the External Device.
• If a serial protocol was selected, choose the port the device will use.
When External Device Definitions have been created, the Source Definition menu lists them
when the
Device Source Type and External Device buttons are selected.
To Next Page
Loading...
