GRASS VALLEY KAYENNE - Changing the Image Store IP Address; Changing Control Panel IP Addresses

Installation & Service Manual
121
2 Select Frame Network Addresses.
3 Under Facility LAN, type in the new IP Address (and subnet mask and gateway if
needed). Make sure you enter the correct number exactly. A typing error can make the
frame inaccessible over the network, since you need to know its IP address for use with
the Web browser.
4 Select the
Save New Settings button.
5 Reset the device.
Result: The device will boot up with the new IP Address.
When a Video Processor Frame IP Address has been changed, communications will no
longer occur with any switcher system devices that are configured to use the old frame IP
Address. You will need to go to each device and change the address they use to
communicate with the Video Processor Frame.
Changing the Image Store IP Address
The Image Store IP address can be changed using the Video Processor Frame web page.
Changing Control Panel IP Addresses
A Control Panel’s IP address can be changed using various methods:
• Switcher Installer program.
• Control Panel Web page, or
• Grass Valley NetConfig application