GRASS VALLEY KAYENNE - Configure Source Definitions

Installation & Service Manual
187
Configure Source Definitions
yellow indications, ensure that channels are in AMP mode and available for remote
control. Other troubleshooting may be required.
Configure Source Definitions
To configure source definitions for ClipStore return outputs, choose a source, a source type
“Device”, an input fed by the device, a Key Mode, and an Engineering Name for the source if
desired.
The following example demonstrates the configuration of a Summit with four ClipStore
channels. In this example the physical BNC connections from the ClipStore to the Frame are
Inputs 25-32.
ClipStore can record Video only, Key only, or Video/Key clips. To do this, both a video and a
key for the video must be configured for each ClipStore channel.
To configure a ClipStore source of a video/key pair as a video fill source:
1 Select
Eng Setup, Source Definition in the menu.
2 From the Source List, select a source.
3 Use the default video input (Video In:) or change it using the
Video Input data pad.
4 Select
Linear Key.
5 Use the
Key Input data pad (or soft knob) to select the source number of the Key source
you will use for the ClipStore channel.
6 Configure the Source Type:
a Select the
Device mode button in the Source Type pane.
b Select the External Device data pad, the External Device List is displayed.