Installation & Service Manual
165
Remote Aux Panel Registration
Remote Aux Panel Registration
Note: Do not confuse the Kayenne or Karrera Local Aux Panels, which are
considered a Control Panel Stripes, with Remote Aux Panels, which are small
panels used to change Aux Bus sources from a different location. The Local
Aux Panel Stripe is not configured with the following menus.
1 Select Eng Setup, Node Settings, Remote Aux IP Network in the GV K-Frame XP GV
switcher menu.
2 Select an available set of buttons and enter an Aux Panel Name and IP address of each
Aux Panel.
3 Identify the type of Remote Aux Panel (Single or Multi- Destination).
4 You can assign the component to a suite and control surface now if you wish but it is
recommended to initially configure your GV K-Frame XP system as a single suite. Later,
you can modify the configuration for multi-suite operation.
Control Panel Brightness Adjustment
All GV K-Frame XP Control Panels are calibrated at the factory for even brightness and color
balance. Individual panel area illumination levels cannot be adjusted in the field. However,
the relative brightness of button tally, source name displays, and text displays can be
adjusted on a global basis to meet individual requirements (for example, to accommodate
varying ambient room lighting levels).
To Next Page
Loading...
