Installation & Service Manual
179
Creating a Bus Relay Tally Calculator
Note: Though the calculator is activated, it will not actually affect Video
Processor Frame relay contacts until that calculator has been assigned to a
Tally Group.
Creating a Bus Relay Tally Calculator
Bus tallies report what source(s) are currently selected on a particular set of buses, and does
not trace tributaries upstream.
Use the Look Ahead Preview procedure above, but choose PGM/PST, ME, or Aux, on the left,
and then select the desired bus in the center of the screen. Repeat for all the buses you wish
to tally.
To Next Page
Loading...
