Installation & Service Manual
33
Retaining Bracket
Button Locks
Compact Frame Power Supply Replacement
4 To install the power supply.
f If the power supply retainer bracket is in the down and locked position (for
example when adding a third, redundant power supply, not replacing one),
perform steps step a, step b, and step c from the Remove the power supply
procedure above.
g Insert the power supply straight into the slot and slide it in until the release button
locks into place.
h On the Retaining Bracket, pull the lock buttons straight forward then slide the
retainer down until it stops and release the lock buttons.
i Verify that the locks are in the closed position and the power supply is completely
seated.
j Close the Compact GV K-Frame XP door, making sure that it latches in the closed
position.
To Next Page
Loading...
