HBM QuantumX - Page 24

Introduction
24 A03031_24_E00_01 HBM: public QuantumX
S The working standard calibration is stored on each amplifier as a calibration
certificate which can be read using the MX Assistant or is available online
via https://www.hbm.com/en/6871/support-download-calibration-certifi
cates/.
S AutoBoot (module configurations are retained)
With amplifiers, the following applies for each measurement channel
S electrical isolation (signal inputs/outputs, power supply, communication),
unless specified otherwise in the data sheet
S Support for TEDS
2)
technology (read, write)
S Configurable sampling rate
S Configurable digital filter (Bessel, Butterworth)
S configurable scaling
Sensors assigned using the sensor database can be calibrated via the channel
and written back into the sensor database.
2)
TEDS = Transducer Electronic Data Sheet