To Next Page

To Previous Page

HDP5000 High Definition Card Printer/Encoder User Guide L000950 Rev 1.8

Using the Optional Printer Fe

atures Group Box__________________________________________274

Using the Event Monitoring Group Box __________________________________________________275

Reviewing the Ribbon Low message __________________________________________________275

Reviewing the Laminate Low Message ________________________________________________275

Using the Film Low message ________________________________________________________276

Selecting the Set Language for Printer LCD Display Group Box ____________________________276

Selecting the Calibrate Laminator tab____________________________________________________277

Selecting the Calibrate Film tab ________________________________________________________278

Selecting the Calibrate Ribbon tab ______________________________________________________279

Selecting the Clean Printer tab _________________________________________________________280

Using the Clean Printer Group Box ___________________________________________________282

Selecting the Advanced Settings tab _____________________________________________________282

Using the Image Darkness Option ____________________________________________________284

Using the Print Top of Form Option___________________________________________________285

Using the Print Left of Form Option __________________________________________________287

Using the Mag Top of Form Option___________________________________________________288

Using the Print Flip Angle Option ____________________________________________________289

Using the Print Flip Level Option ____________________________________________________289

Using the Encoder Flip Angle Option _________________________________________________290

Setting the Printhead Resistance______________________________________________________290

Using the Transfer TOF Adjustment Option ____________________________________________290

Using the Transfer Temp Offset Option________________________________________________292

Using the Ribbon Print Takeup Tension Option__________________________________________292

Using the Film Print Takeup Tension Option____________________________________________292

Using the Ribbon Print Supply Tension Option __________________________________________293

Using the Film Supply Transfer Tension Option _________________________________________294

Using the Film Takeup Transfer Tension Option_________________________________________294

Using the Resin Heat Adjust Option___________________________________________________295

Using the Sleep Time Option ________________________________________________________295

Using the Standby Time Option ______________________________________________________295

Using the Blush Point Option________________________________________________________295

Using the LCD Contrast Option ______________________________________________________295

Using the Cleaning rate Option ______________________________________________________295

Using the EAT Disable Option_______________________________________________________296

Using the Film Print Cooling Level Option _____________________________________________296

Using the Film Transfer Cooling Level Option __________________________________________296

Using the Enable Ribbon Wrinkle Compensation Option __________________________________296

Using the Holo Transfer Offset Option ________________________________________________296

Using the Standby Temp Option _____________________________________________________296

Using the Mag Hi-Co Voltage Offset Option____________________________________________297

Using the Mag Lo-Co Voltage Offset Option____________________________________________297

Using the Mag Flipper Angle Offset Option ____________________________________________297

Using the Lamination Top of Form Option _____________________________________________297

Using the Lamination End of Form Option _____________________________________________297

Using the Lamination Bottom Takeup Option ___________________________________________297

Using the Lamination Top Takeup Option______________________________________________297

Using the Lamination Card Backup Option _____________________________________________298

Using the lamination Card Length Option ______________________________________________298

Reviewing the No Printer Connected error message ______________________________________298

Reviewing the Value outside the Range error message ____________________________________298

Section 11: Cleaning __________________________________________________________ 299

Using the Required Supplies___________________________________________________________299

Accessing the Clean Printer tab_________________________________________________________300

Cleaning the Printer Platen Roller and Card Feed Rollers __________________________________300

Cleaning inside the Printer __________________________________________________________303

Print Resolution	300 dpi
Interface	USB
Print Technology	Dye sublimation
Card Capacity	100-card input hopper
Connectivity	USB 2.0
Print Capability	Single-sided
Operating System Support	Windows 7, 8, 10
Card Sizes	CR80 (standard credit card size)

HID HDP5000 User Manual

Table of Contents

Questions and Answers:

HID HDP5000 Specifications

Related product manuals