ID2000 Series Industrial Code Reader User Manual
9
Figure 3-7 Appearance (Type VII)
Table 3-1 Component Description
It is used to adjust focal length manually.
It is used to fix the device to the installation position.
It is used to trigger the device or execute smart tune process.
●
Trigger button: When the device is in trigger mode, press the
button and the device triggers once.
●
Smart tune button: Hold the button for 3 sec and the device
starts smart tune. Hold the button for 3 sec again during smart
tune process, and the adjustment will be cancelled.
Note
The specific function of the button may differ by device models.
SR cable connector provides power, I/O, Ethernet, and serial port.
Note
The specific function of the SR cable may differ by device models.
It is a network status indicator. The indicator is flashing green
when the network transmission is normal. Otherwise, it is unlit.
Note
Type VI and type VII devices do not have a LNK indicator.
●
It is in red color when the device starts up or or operation error
occurs.
●
It is unlit when the device operates normally without reading
codes.
To Next Page
Loading...
