HIKVISION DeepinMind Series - Add Network Camera Manually

Note
If the network camera to add has not been acvated, you can acvate it in the network camera
list of camera management interface.
1.4.2 Add Network Camera Manually
Before you view live video or record video les, you must add network cameras to the device.
Before You Start
Ensure the network
connecon is valid and correct, and the network camera is acvated.
Steps
1. Click on the main menu.
2. Click Custom Adding.
3. Set IP Camera Address, Protocol, Management Port, Transfer Protocol, User Name, and
Password. Management port ranges from 1 to 65535.
Figure 1-11 Add Network Camera
4. Oponal: Check Use Channel Default Password to use the default password to add the camera.
5. Oponal: Check Use Default Port to use the default management port to add the camera. For
SDK service, the default port value is 8000. For enhanced SDK service, the default value is 8443.
Note
The funcon is only available when you use HIKVISION protocol.
Network Video Recorder User Manual
9