Hill-Rom Affinity Three - Page 17

Safety Tips
Chapter 1: Introduction
Affinity® Three Birthing Bed and Affinity® Four Birthing Bed Page 1 - 7
Service Manual (MAN272 REV 4)
1
WARNING:
Ensure that the bed is stable before removing the caster. Failure to do
so could result in personal injury or equipment damage.
WARNING:
Follow the product manufacturer’s instructions. Failure to do so could
result in personal injury or equipment damage.
WARNING:
Adhere to the Infection Control Policies and Procedures from Hill-Rom.
Failure to do so could result in the spread of infection.
WARNING:
Powered bed mechanisms can cause serious injury. Operate the bed
only with persons clear of mechanisms. Failure to do so could result in
personal injury or equipment damage.
WARNING:
Unplug the bed from its power source and engage the lockout control
during routine maintenance or cleaning. Refer to the Affinity® Three
Birthing Bed and Affinity® Four Birthing Bed User Manual (USR025)
and specific sections in this service manual for additional precautions.
Failure to do so could result in personal injury or equipment damage.
WARNING:
Ensure that all electrical/mechanical loads are removed prior to
maintenance/repair of the bed’s drive system or other mechanical
assemblies. Failure to do so could result in personal injury or equipment
damage.
WARNING:
Visually inspect the bushings annually. If wear is apparent, replace
them. Failure to do so could result in personal injury or equipment
damage.