Hill-Rom Affinity Three - Page 16

Safety Tips
Chapter 1: Introduction
Page 1 - 6 Affinity® Three Birthing Bed and Affinity® Four Birthing Bed
Service Manual (MAN272 REV 4)
WARNING:
Prop up the head section before removing the cotter pins and clevis
pins. Failure to do so could result in personal injury or equipment
damage.
WARNING:
You must use the 2" x 4" pieces of lumber to support the foot yoke. The
foot yoke will fall during this procedure if not supported. Failure to do so
could result in personal injury or equipment damage.
WARNING:
The head end of the main frame is supported by the two Trend-Like
position gas springs. Any servicing will require that a support device be
placed just beneath the head end of the main frame. Failure to do so
could result in personal injury or equipment damage.
WARNING:
Do not attempt to remove the gas spring with the head section fully
raised and the spring compressed. Lower the head section until the
cylinder of the gas spring is free in the slide bracket of the main frame,
and support the head section securely before removing the cotter pins
and clevis pins. Failure to do so could result in personal injury or
equipment damage.
WARNING:
Failure to properly mount the foot section to the yoke latches could
result in equipment damage or personal injury.
WARNING:
Failure to properly mount the foot section to the yoke slide brackets
could result in equipment damage or personal injury.
WARNING:
Adhere to all electrical safety precautions when servicing the bed's
electrical system. Failure to do so could result in personal injury or
equipment damage.