Hill-Rom Affinity Three - Page 20

Safety Tips
Chapter 1: Introduction
Page 1 - 10 Affinity® Three Birthing Bed and Affinity® Four Birthing Bed
Service Manual (MAN272 REV 4)
CAUTION:
Remove the battery if the bed will not be in service for extended periods
of time. Failure to do so could result in damage to the life of the battery,
or damage to the bed. Contact the appropriate maintenance personnel.
CAUTION:
Do not position the head of the bed against a wall or beneath any
fixtures. This is to prevent damage due to the arcing motion of the bed
while the bed is being raised and lowered.
CAUTION:
Ensure that the night light is not damaged when the bed is being
lowered. Failure to do so could result in equipment damage.
CAUTION:
Do not pull on the mattress material when unfastening the mattress
retaining snaps. Unfasten the mattress retaining snaps at the snap
location. Failure to do so could result in equipment damage.
CAUTION:
Ensure that the fuse housing is properly oriented for the voltage rating
(110-120V or 220-240V) on the bed that you are servicing. Failure to do
so could result in equipment damage.
CAUTION:
Do not cut or remove the cable ties that secure the battery leads to the
electronics pan. This ensures the proper connection of the batteries
during the replacement procedure. Possible equipment damage could
occur if the cable ties are removed.
CAUTION:
To prevent component damage, ensure that your hands are clean, and
only handle a P.C. board by its edges. Failure to do so could result in
equipment damage.