116
Timing Chart
(2) Measurement with internal trigger setting
INDEX
EOM
t1
t2
t3
V_CHECK_GO
t4
C_CHECK_GO
HI, IN, LO,
PASS, FAIL,
ERR
ON
ON
OFF
OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFFON/OFF
OFF
Item Contents Time
t1 INDEX time ([Contact checking time] + [Delay time] + [Measurement
time]) or less
t2 EOM time (INDEX + [Comparator measurement time] + 0.4 ms) or less
Add 1.0 ms, however, if calculating a resistance measured
value from a voltage measured value
t3 Internal TRIG setup time 40 ms ±5 ms
t4 Judgment setup time
Time required for the EOM
signal to output after output of a
judgment signal
70 µs or more
To Next Page
Loading...
