Hioki Super megohm SM7110 - Settings Common to Interfaces

130
USB Interface
10.2 USB Interface
Installing the USB driver
When the instrument is rst connected to a computer, it is necessary to install the dedicated USB
driver. If the driver has already been installed, skip the following procedure. The accompanying CD
contains the USB driver. It can also be downloaded from the Hioki website.
Installation procedure
Install the USB driver before connecting the instrument to a computer with a USB cable. If the USB
cable has been already connected to the computer, unplug it.
1
Log into the computer with administrative privileges such as “administrator.”
2
Exit all applications that are running on the computer.
3
Open [X:\USB Driver] from the accompanying CD, and run [HiokiUsbCdcDriver.msi] (driver
installer ) (The drive name “X:” represents the CD-ROM drive).
It may take some time for the dialog box is displayed, depending on the system environment. Wait
for the dialog box to be displayed.
4
After the installation is completed, connect the instrument and the computer with a USB
cable.
The instrument is now recognized.
• If the Hardware Wizard window for new hardware is displayed, select [No, not this time] for the Windows
Update connection prompt, and then select [Install the software automatically].
• If an instrument with a di󰀨erent serial number is connected, you may be notied that a new device has been
detected. If this happens, install the USB driver, following the instructions on the screen.
Uninstallation procedure
Uninstall the driver if you no longer need it.
On the [Control Panel], click [Add or Remove Programs], and then uninstall [HOIKI USB CDC
Driver].
Connecting the USB cable
Be sure to read “Before connecting the communication cable to the instrument” (p. 14)
beforehand.
The USB cable shall have length of 3 m or less.
Rear
Computer’s USB interface
Type B