Hioki Super megohm SM7110 - Limiting Current Flowing Through Measured Object (Current Limiter)

59
Changing Measurement Starting Conditions (Trigger Function)
Inputting an external trigger
• For inputting triggers using the keys
After the START key is pressed on the Measurement screen, when the ENTER (TRIG) key is
pressed, a measurement is performed once.
• For inputting triggers to the EXT I/O
When the TRIG terminal of the EXT I/O terminal on the rear is short-circuited with the ISO_COM
terminal, a measurement is performed once. (p. 110)
• For inputting triggers to the communications interface
When the command
*TRG
is sent to the communication interface, a measurement is performed
once.
IMPORTANT
• If it is set to the internal trigger, the trigger input to the EXT I/O and the command
*TRG
are
ignored.
• Measurement can be interrupted in the middle by pressing the STOP key.
4
Applied Measurement