128
Settings for External Input and Output
EOM signal output mode
This setting can be used to specify the output method for the EOM (end of measurement) signal.
Procedure to display the setting screen: MENU key >
[I/O] tab
1
Select whether to maintain the EOM signal in the on state or to switch it to the o state
after the set time has elapsed.
[HOLD] The EOM signal output remains in the on state until the next TRIG signal is input (default
setting).
[PULSE] The EOM signal output remains in the o state after the set pulse width has elapsed.
2
If [PULSE] is selected, set the pulse width.
1 ms to 100 ms (default setting: 1 ms)
Pressing the F4 key
[EDIT] enables the
numerical value to be
changed.
Settle
Cancel
Move to the next
digit (left or right)
Change the
numerical value
(up or down)
Numerical value can also be changed with the numeric keypad. See “Methods for changing
numerical values” (p. 28).
To Next Page
Loading...
