Hioki Super megohm SM7110 - Interface Specifications

152
Interface Specications
11.4 Interface Specications
The underlined values are the default settings. The set values are retained even after the instrument is turned o󰀨.
USB Communication
contents
Remote control, measured value output
Connector Series B receptacle
Electrical
specications
USB2.0 (Full Speed)
Class (mode)
CDC class (COM mode)
HID class (USB keyboard mode)
RS-232C Communication
contents
Remote control, measured value output
Transmission
method
Start-stop synchronization system, full duplex
Transmission
speed
4800 bps/9600 bps/19200 bps/38400 bps/115200 bps
Data bit length 8 bits
Stop bit 1
Parity bit None
Delimiter Sending: CR + LF; Receiving: CR, CR + LF
Handshake X ow: Not provided, Hardware ow: Not provided
Protocol Non-procedure system
Connector D-sub 9 pins, male, mating xed base screw #4-40
GP-IB Communication
contents
Remote control
Device address
0 to 30, default: 1
Delimiter
LF/CR + LF
Other IEEE488.2 compliant
Interface functions
SH1 Provides all source handshake functions.
AH1 Provides all acceptor handshake functions.
T6 Provides a basic talker function.
Provides a serial poll function.
Does not provide talk-only mode.
Provides a function to release the talker using the MLA (My Listen Address).
L4 Provides a basic listener function.
Does not provide a listen-only mode function.
Provides a function to release the listener using the MTA (My Talk Address).
SR1 Provides all service request functions.
RL1 Provides all remote/local functions.
PP0 Does not provide parallel poll functions.
DC1 Provides all device clear functions.
DT1 Provides all device trigger functions.
C0 Does not provide a controller function.