123
Assembling Male Connector for EXT I/O (Accessory)
9.5 Assembling Male Connector for EXT I/O
(Accessory)
The male connector for the EXT I/O is supplied along with the instrument. Assemble the connector,
referring to the gure below.
• Use a shielded wire for the cable that connects the EXT I/O connector to a device, such as PLC.
Otherwise, the system may malfunction due to noise.
• Connect the shield of the wire to the ISO_COM terminal of the EXT I/O connector.
Required items:
• Screwdriver
• Cable (shielded wire recommended)
• Soldering iron
• Male connector for EXT I/O (accessory)
A: Hood (The upper and lower hoods have the
same shape) ...........................................×2
B: Screw (Phillips slot combination)
#4-40UNC (total length: 16.9 mm) ..........×2
C: Screw (Phillips slot combination)
#4-40UNC (total length: 12.6 mm) ..........×2
D: Screw (slotted)
#4-40UNC (total length: 15.0 mm) ..........×2
E: Nut #4-40UNC ........................................×2
F: Fastener (for cable) ................................×2
G: Fastener (case protection) ...................... ×2
H: Connector ...............................................×1
1
Solder the cable to the connector (H).
2
Attach the fasteners (F) to the cable with
the screws (C).
3
Set the fasteners (F) in the predetermined
position on one of the hoods (A).
4
Insert the screws (D) into the fasteners
(G).
5
Set the connector (H), fasteners (G), and
screws (D) in the predetermined position
on the hood (A) described in step 3.
6
Place the other hood (A) from above.
7
Secure the hoods (A) with each other
with the screws (B) and the nuts (E).
Do not tighten the screws more than required,
because doing so may damage the hoods.
B
F
F
C
C
G
G
H
D
D
E
A
Cable
(shielded wire recommended)
EXT I/O terminal of the
instrument
A
E
B
9
External Control (EXT I/O)
To Next Page
Loading...
