104
Preventing Test From Being Incorrectly Started (Double Action Function)
8.5
Preventing Test From Being Incorrectly Started
(Double Action Function)
When the double action function is set to [ON], incorrect starts of tests can be prevented, resulting
in safety improvement of tests.
Procedure to display the setting screen: (Measurement screen) MENU key >
[SYS] tab
[ON] To start a measurement, press the STOP key, and then, press the START key within
approximately 1 second (default setting).
[OFF] To start a measurement, press the START key.
If the double action function is set to [ON], pressing the START key without pressing the STOP key causes
the beep sound to be emitted and an error to appear.
8.6 Adjusting Screen Contrast
The visibility of the screen may not be clear at some ambient temperatures. The visibility of the
screen can be adjusted by adjusting the screen contrast.
Procedure to display the setting screen: (Measurement screen) MENU key >
[SYS] tab
0% to 100%, in increments of 5% (default setting: 50%)
Press the F3 key [↓] or F4 key [↑] to change the value.
To Next Page
Loading...
