3-8
OPERATING THE ENGINE
MDCD-01-026
5
4
f
NOTE: When the key switch is turned ON, maintenance
notification (4) for the item whose maintenance interval
has expired displays for 10 seconds. Push Return to Previous
Screen switch (5) or turn the pilot control shut-off lever to the
UNLOCK position while the rear view camera is enabled to
delete the notification.
7. The Basic Screen will be displayed on the monitor.
The machine will automatically check if preheating is
required or not. When preheating is required, preheat
indicator (6) is lit for automatically.
f
NOTE: In case, preheat indicator (6) does not come ON,
preheating is not required. Follow the "Starting the Engine in
Ordinary Temperature" section.
8. As soon as preheat indicator (6) goes OFF, turn key
switch to START position to rotate the starter.
IMPORTANT: Never operate the starter for more than 10
seconds at a time. If the engine fails to start, return
the key switch to the OFF position. Wait for more than
30 seconds, then try again. Failure to do so may cause
damage to the starter and/or discharge the batteries.
Basic Screen
6
MDC1-01-042
MDC1-01-213EN
To Next Page
Loading...
Need help?
General
