HP 5120 SI Series

41
If no IRF member ID is specified, the command will display the configuration information of the RADIUS
schemes on all members of an IRF virtual device.
Related commands: radius scheme.
Examples
# Display the configuration information of all RADIUS schemes.
<Sysname> display radius scheme
------------------------------------------------------------------
SchemeName : radius1
Index : 0 Type : extended
Primary Auth Server:
IP: 1.1.1.1 Port: 1812 State: active
Encryption Key : ******
Probe username : test
Probe interval : 60 min
Primary Acct Server:
IP: 1.1.1.1 Port: 1813 State: active
Encryption Key : ******
Second Auth Server:
IP: 1.1.2.1 Port: 1812 State: active
Encryption Key : N/A
IP: 1.1.3.1 Port: 1812 State: active
Encryption Key : N/A
Probe username : test
Probe interval : 60 min
Second Acct Server:
IP: 1.1.2.1 Port: 1813 State: block
Encryption Key : N/A
Probe username : test
Probe interval : 60 min
Auth Server Encryption Key : ******
Acct Server Encryption Key : N/A
Accounting-On packet disable, send times : 5 , interval : 3s
Interval for timeout(second) : 3
Retransmission times for timeout : 3
Interval for realtime accounting(minute) : 12
Retransmission times of realtime-accounting packet : 5
Retransmission times of stop-accounting packet : 500
Quiet-interval(min) : 5
Username format : without-domain
Data flow unit : Byte
Packet unit : one
NAS-IP address : 1.1.1.1
Attribute 25 : car
------------------------------------------------------------------
Total 1 RADIUS scheme(s).