EasyManuals Logo

HP ProCurve 5400zl User Manual

HP ProCurve 5400zl
765 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
The rst form of the command sets the
MAC address format which is common to all ports
The second form of the command enables, disables, or
congures authentication on the device's individual ports.
o 'addr-format' sets the MAC address format to be used in the
RADIUS request message (default no-delimiter).
o 'addr-limit' sets the maximum number of MAC addresses to
allow on the port. This includes ALL addresses (authenticated
and unauthenticated). The default is 1 MAC address.
NOTE: No more than 32 unique client MAC addresses can be
authorized by both 802.1X and MAC/web-based
authentication together on the same port.
o 'addr-moves' sets whether the MAC address can move
between ports that also have 'addr-moves' enabled
(default disabled - no moves allowed).
o 'quiet-period' sets the period of time during which the
switch does not try to authenticate after a failed
authentication attempt (default 60 seconds).
o 'server-timeout' sets the period of time after which the
switch assumes that authentication has timed out
(default 30 seconds).
o 'max-requests' sets the number of authentication attempts
that must time out before authentication fails (default 3).
o 'logoff-period' sets the period of time of inactivity that
the switch considers an implicit logoff (default 300).
o 'reauth-period' sets the period of time after which connected
MAC addresses must be re-authenticated. When set to 0
the re-authentication is disabled (default 0).
o 'auth-vid' congures the VLAN to which to move a port
after successful authentication. RADIUS server can
override the value. Use 'no' form of the command to set
this PVID to 0. If the PVID is set to 0 no PVID changes
occur unless RADIUS server requests. Changes take effect
immediately. All clients must immediately re-authenticate.
The default is 0.
o 'unauth-vid' congures the VLAN to which to move a port
after failed authentication. Use 'no' form of the command
to set this PVID to 0. Changes take effect immediately.
The default is 0.
o 'reauthenticate' forces re-authentication
of all clients present on a port.
Next Available Options:
â–  mac-list1 -- Manage MAC address based network authentication on the device port(s). ([ethernet]
PORT-LIST) (p. 39)
38© 2009 Hewlett-Packard Development Company, L.P.
aaaCommand Line Interface Reference Guide

Table of Contents

Other manuals for HP ProCurve 5400zl

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 5400zl and is the answer not in the manual?

HP ProCurve 5400zl Specifications

General IconGeneral
BrandHP
ModelProCurve 5400zl
CategorySwitch
LanguageEnglish

Related product manuals