â– vlan VLAN-ID ip ospf all area backbone
The backbone area (the same as 0.0.0.0).
backup
â– vlan VLAN-ID vrrp vrid < 1 to 255 > backup
Usage: vrrp vrid <VRID> backup
Description: Designate the virtual router instance as a Backup.
There is no default value.
binary-range
â– vlan VLAN-ID qos dscp < 0 to 63 >
Specify the DSCP code-point in binary.
Range: < 0 to 63 >
blocked
â– vlan VLAN-ID ip igmp blocked [ETHERNET] PORT-LIST
Usage: ip igmp blocked [ethernet] PORT-LIST
Description: Instruct the device to drop incoming multicast packets
received on the speciîš¿ed ports. This feature is
conîš¿gured on a per-VLAN basis.
â– vlan VLAN-ID ipv6 mld blocked [ETHERNET] PORT-LIST
Usage: vlan < vid > ipv6 mld blocked < port-list >
Description: Instruct the device to drop incoming multicast packets
received on the speciîš¿ed ports. This feature is
conîš¿gured on a per-VLAN basis.
bootp-gateway
â– [no] vlan VLAN-ID ip bootp-gateway
Usage: [no] ip bootp-gateway [IP-ADDR]
Description: Add or remove the gateway address to be used for stamping
incoming DHCP requests.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
Next Available Option:
â– ip-addr -- IPv4 address of the BOOTP gateway. (IP-ADDR) (p. 729)
chain-name
â– vlan VLAN-ID ip ospf md5-auth-key-chain CHAIN-NAME
Specify key chain to use for MD5 authentication.
720© 2009 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide
To Next Page
Loading...
Need help?
General