HP StorageWorks 300 - Virtual Library System EVA Gateway - Page 111

Command
Usage
1
getLibs
Returns a list of the libraries defined on the VLS.
getLib
Returns a summary of the specified library. Where the options
are:
-a <s> - Name of library (Library_0, ....) (required)
-h - Displays command usage information (optional)
getLibOpenSlots
Returns a summary of the slot status for each defined library
(open:used:total) .
destroyLib
Deletes the specified library from the VLS. This operation takes
several minutes to perform. Where the options are:
-a <n> -Nodenumberonwhichthelibraryemulationresides
(0, ...) (optional)
-f - Force. Do the destroy without a prompt (optional)
-l <n> - LUN number of the library to delete (required)
-h - Displays command usage information (optional)
getTapeTypes
Returns a list of a l l tape drive emulation types available.
Displays each tape drive emulation’s name, type, product,
revision, and vendor information.
createTapeDrive
Creates the specified number of tape drives of a particular
type and associates them with the specified library. Where
the options are:
-a <n> -NodeIDofnodeonwhichthetapedriveemulation
will reside (0, ....) (required)
-c <n> - Data compression (0=Disabled, 1=Enabled)
(required)
-l <n> - LUN number to assign to tape drive (-1 to 128)
(optional)
-la <n> -Nodenumberonwhichthelibraryemulationof
the library to associate with the tape drive(s) resides (0 to 3)
(required)
-ll <n> - LUN number of library with which to associate tape
drive (0, 1, ...) (required)
-n <n> - Number of tape drives (required)
-p <s> - Product (DLT7000, SDLT320, ...) (required)
-pm <n> -FCporttowhichthistapedriveismapped.
(required)
-r <s> - Revision (R138, ...) (required)
-t <s> - Tape drive type name (required)
-v <s> - Vendor (Quantum, HP, ...) (required)
-y <n> -Tapedrivetype(3,4,...) (required)
-h - Displays command usage information (optional)
getTapeDrives
Returns a list of all tape drives defined in the VLS. Where the
options are:
-a <s> - Library name (Library_0, ...) (required)
-h - Displays command usage information (optional)
getTapeD
rive
Returns the configuration information for the specified tape
drive. Where the options are:
-a <s> - Name of desired tape drive (TapeDrive_1, ...)
(required)
-l <s> - Name of library with which tape drive is associated
(Library_0, ...) (required)
-h - Displays command usage information (optional)
HP StorageWorks
111