HPE FlexNetwork MSR Series Comware 7 Layer 3 - Ip Services Configuration Guides

143
• When the destination IP address of a packet from the public network matches the public
address range, the destination IP address is translated into a private address in the private
address range.
To configure outbound net-to-net static NAT:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Configure a net-to-net
mapping for outbound static
NAT.
nat static outbound net-to-net
local-start-address
local-end-address [
vpn-instance
local-vpn-instance-name ]
global
global-network { mask-length |
mask } [
vpn-instance
global-vpn-instance-name ] [
acl
{ ipv4-acl-number |
name
ipv4-acl-name } [
reversible
] ]
[
disable
]
By default, no mappings exist.
If you specify the
acl
keyword,
NAT processes only packets
permitted by the ACL.
3. Return to system view.
quit
N/A
4. Enter interface view.
interface
interface-type
interface-number
N/A
5. Enable static NAT on the
interface.
nat static enable
By default, static NAT is disabled.
Configuring object group-based outbound static NAT
Configure object group-based outbound static NAT on the interface connected to the external
network to translate private IP addresses into public IP addresses.
• When the source address of a packet from the private network matches the private address
object group, the source address is translated into a public address in the public address object
group.
• When the destination address of a packet from the public network matches the public address
object group, the destination address is translated into a private address in the private address
object group.
To configure object group-based outbound static NAT:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Configure an object
group-based outbound static
NAT mapping.
nat static outbound
object-group
local-object-group-name
[
vpn-instance
local-vpn-instance-name ]
object-group
global-object-group-name
[
vpn-instance
global-vpn-instance-name ] [
acl
{ ipv4-acl-number |
name
ipv4-acl-name } [
reversible
] ]
[
disable
]
By default, no mappings exist.
If you specify the
acl
keyword,
NAT processes only packets
permitted by the ACL.
3. Return to system view.
quit
N/A
4. Enter interface view.
interface
interface-type
N/A

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English