HPE FlexNetwork MSR Series Comware 7 Layer 3 - Ip Services Configuration Guides

445
AFT configuration task list
IPv6-initiated communication
Task at a glance
(Required.) Enabling AFT
(Required.) Configuring an IPv6-to-IPv4 destination address translation policy
(Required.) Configuring an IPv6-to-IPv4 source address translation policy
(Optional.) Configuring AFT logging
(Optional.) Setting the ToS field to 0 for translated IPv4 packets
IPv4-initiated communication
Task at a glance
(Required.) Enabling AFT
(Required.) Configuring an IPv4-to-IPv6 destination address translation policy
(Required.) Configuring an IPv4-to-IPv6 source address translation policy
(Optional.) Configuring AFT logging
(Optional.) Setting the Traffic Class field to 0 for translated IPv6 packets
Enabling AFT
To implement address translation between IPv4 and IPv6 networks, you must enable AFT on
interfaces connected to the IPv4 network and interfaces connected to the IPv6 network.
To enable AFT:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Enable AFT.
aft enable
By default, AFT is disabled.
Configuring an IPv6-to-IPv4 destination address
translation policy
AFT compares an IPv6 packet with IPv6-to-IPv4 destination address translation policies in the
following order:
1. IPv4-to-IPv6 source address static mappings.
2. General prefixes.
3. NAT64 prefixes.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English