HPE FlexNetwork MSR Series Comware 7 Layer 3 - Ip Services Configuration Guides

327
# Create the 6to4 tunnel interface Tunnel 0.
[RouterB] interface tunnel 0 mode ipv6-ipv4 6to4
# Specify an IPv6 address for the tunnel interface.
[RouterB-Tunnel0] ipv6 address 2003::1/64
# Specify GigabitEthernet 2/0/2 as the source interface of the tunnel interface.
[RouterB-Tunnel0] source gigabitethernet 2/0/2
[RouterB-Tunnel0] quit
# Configure a static route destined for 2002::/16 through the tunnel interface.
[RouterB] ipv6 route-static 2002:: 16 tunnel 0
Verifying the configuration
# Verify that Linux-running hosts Host A and Host B can ping each other.
D:\>ping6 -s 2002:201:101:1::2 2001::2
Pinging 2001::2
from 2002:201:101:1::2 with 32 bytes of data:
Reply from 2001::2: bytes=32 time=13ms
Reply from 2001::2: bytes=32 time=1ms
Reply from 2001::2: bytes=32 time=1ms
Reply from 2001::2: bytes=32 time<1ms
Ping statistics for 2001::2:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 13ms, Average = 3ms
Configuring an ISATAP tunnel
Follow these guidelines when you configure an ISATAP tunnel:
• You do not need to configure a destination address for an ISATAP tunnel, because the
destination IPv4 address is embedded in the ISATAP address.
• Do not specify the same source addresses for local tunnel interfaces in the same tunnel mode.
• Because automatic tunnels do not support dynamic routing, configure a static route destined for
the destination IPv6 network at each tunnel end. You can specify the local tunnel interface as
the egress interface of the route or specify the IPv6 address of the peer tunnel interface as the
next hop of the route. For more information about route configuration, see Layer 3—IP Routing
Configuration Guide.
To configure an ISATAP tunnel:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter ISATAP tunnel
interface view.
interface tunnel
number [
mode
ipv6-ipv4 isatap
]
N/A
3. Specify an IPv6 address for
the tunnel interface.
See "Configuring basic IPv6
settings."
By default, no IPv6 address is
configured for the tunnel
interface.
4. Configure a source address
or source interface for the
source
{ ipv4-address | By default, no source address or

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English