HPE FlexNetwork MSR Series - Configuring Ipv6 Prefix Acquisition; Configuring Ipv6 Address and Prefix Acquisition; Configuring Stateless Dhcpv6

289
Step Command Remarks
3. Configure the interface to
use DHCPv6 to obtain an
IPv6 address and other
configuration parameters.
ipv6 address dhcp-alloc
[
option-group
group-number |
rapid-commit
] *
By default, the interface does not
use DHCPv6 for IPv6 address
acquisition.
Configuring IPv6 prefix acquisition
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
Supported interfaces include
Layer 3 Ethernet interface, Layer
3 Ethernet subinterface, Layer 3
aggregate interface, Layer 3
aggregate subinterface, and
VLAN interface.
3. Configure the interface to
use DHCPv6 to obtain an
IPv6 prefix and other
configuration parameters.
ipv6 dhcp client pd
prefix-number [
option-group
group-number |
rapid-commit
] *
By default, the interface does not
use DHCPv6 for IPv6 prefix
acquisition.
Configuring IPv6 address and prefix acquisition
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
Supported interfaces include
Layer 3 Ethernet interface, Layer
3 Ethernet subinterface, Layer 3
aggregate interface, Layer 3
aggregate subinterface, and
VLAN interface.
3. Configure the interface to
use DHCPv6 to obtain an
IPv6 address, an IPv6 prefix,
and other configuration
parameters.
ipv6 dhcp client stateful prefix
prefix-number [
option-group
option-group-number |
rapid-commit
] *
By default, the interface does not
use DHCPv6 for IPv6 address
and prefix acquisition.
Configuring stateless DHCPv6
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
Supported interfaces include
Layer 3 Ethernet interface, Layer
3 Ethernet subinterface, Layer 3
aggregate interface, Layer 3
aggregate subinterface, and
VLAN interface.