47
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a DHCP address pool
and enter its view.
dhcp server ip-pool
pool-name
By default, no DHCP
address pool exists.
3. Specify gateways.
gateway-list
ip-address&<1-64>
By default, no gateway is
specified.
4. (Optional.) Enter secondary
subnet view
network
network-address [ mask-length
|
mask
mask ]
secondary
N/A
5. (Optional.) Specify gateways.
gateway-list
ip-address&<1-64>
By default, no gateway is
specified.
Specifying a domain name suffix for DHCP clients
You can specify a domain name suffix in a DHCP address pool on the DHCP server. With this suffix
assigned, the client only needs to input part of a domain name, and the system adds the domain
name suffix for name resolution. For more information about DNS, see "Configuring DNS."
To configure a domain name suffix in the DHCP address pool:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a DHCP address pool
and enter its view.
dhcp server ip-pool
pool-name
By default, no DHCP address
pool exists.
3. Specify a domain name suffix.
domain-name
domain-name
By default, no domain name is
specified.
Specifying DNS servers for DHCP clients
To access hosts on the Internet through domain names, a DHCP client must contact a DNS server to
resolve names. You can specify up to eight DNS servers in a DHCP address pool.
To specify DNS servers in a DHCP address pool:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a DHCP address pool
and enter its view.
dhcp server ip-pool
pool-name
By default, no DHCP
address pool exists.
3. Specify DNS servers.
dns-list
ip-address&<1-8>
By default, no DNS server is
specified.
Specifying WINS servers and NetBIOS node type for DHCP
clients
A Microsoft DHCP client using NetBIOS protocol must contact a WINS server for name resolution.
You can specify up to eight WINS servers for such clients in a DHCP address pool.
To Next Page
Loading...
