HPE FlexNetwork MSR Series Comware 7 Layer 3 - Ip Services Configuration Guides

235
To generate a temporary address, an interface must be enabled with stateless address
autoconfiguration. Temporary IPv6 addresses do not overwrite public IPv6 addresses, so an
interface can have multiple IPv6 addresses with the same address prefix but different interface IDs.
If an interface fails to generate a public IPv6 address because of a prefix conflict or other reasons, it
does not generate any temporary IPv6 address.
Prefix-specific address autoconfiguration
This task allows you to specify an IPv6 prefix for an interface to automatically generate an IPv6
global unicast address and advertise the prefix. You must specify the IPv6 prefix by its ID.
To specify an IPv6 prefix for an interface to generate an IPv6 address and advertise the prefix:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Configure an IPv6 prefix.
• (Method 1) Configure a static
IPv6 prefix:
ipv6 prefix prefix-number
ipv6-prefix/prefix-length
• (Method 2) Use DHCPv6 to
obtain a dynamic IPv6 prefix:
For more information about
IPv6 prefix acquisition, see
"Configuring the DHCPv6
client."
By default, no static or dynamic
IPv6 prefixes exist.
3. Enter interface view.
interface
interface-type
interface-number
N/A
4. Specify an IPv6 prefix for
an interface to
automatically generate an
IPv6 global unicast
address and advertise the
prefix.
ipv6 address
prefix-number
sub-prefix/prefix-length
By default, no IPv6 prefix is
specified for the interface to
automatically generate an IPv6
global unicast address.
Configuring an IPv6 link-local address
Configure IPv6 link-local addresses using one of the following methods:
• Automatic generation—The device automatically generates a link-local address for an
interface according to the link-local address prefix (FE80::/10) and the link-layer address of the
interface.
• Manual assignment—Manually configure an IPv6 link-local address for an interface.
An interface can have only one link-local address. As a best practice, use the automatic generation
method to avoid link-local address conflicts. If both methods are used, the manual assignment takes
precedence.
• If you first use automatic generation and then manual assignment, the manually assigned
link-local address overwrites the automatically generated one.
• If you first use manual assignment and then automatic generation, both of the following occur:
{ The link-local address is still the manually assigned one.
{ The automatically generated link-local address does not take effect. If you delete the
manually assigned address, the automatically generated link-local address takes effect.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English