HPE FlexNetwork MSR Series - Configuring Option 184 Parameters for DHCP Clients; Customizing DHCP Options

50
Configuring Option 184 parameters for DHCP clients
To assign calling parameters to DHCP clients with voice service, you must configure Option 184 on
the DHCP server. For more information about Option 184, see "Option 184."
To configure option 184 parameters in a DHCP address pool:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a DHCP address pool and
enter its view.
dhcp server ip-pool
pool-name
By default, no DHCP
address pool exists.
3. Specify the IP address of the
primary network calling
processor.
voice-config ncp-ip
ip-address
By default, no primary
network calling processor is
specified.
After you configure this
command, the other Option
184 parameters take effect.
4. (Optional.) Specify the IP address
for the backup server.
voice-config as-ip
ip-address
By default, no backup
network calling processor is
specified.
5. (Optional.) Configure the voice
VLAN.
voice-config voice-vlan
vlan-id
{
disable
|
enable
}
By default, no voice VLAN is
configured.
6. (Optional.) Specify the failover IP
address and dialer string.
voice-config fail-over
ip-address
dialer-string
By default, no failover IP
address or dialer string is
specified.
Customizing DHCP options
IMPORTANT:
Use caution when customizing DHCP options because the configuration might affect DHCP
operation.
You can customize options for the following purposes:
• Add newly released options.
• Add options for which the vendor defines the contents, for example, Option 43.
• Add options for which the CLI does not provide a dedicated configuration command. For
example, you can use the option 4 ip-address 1.1.1.1 command to define the time server
address 1.1.1.1 for DHCP clients.
• Add all option values if the actual requirement exceeds the limit for a dedicated option
configuration command. For example, the dns-list command can specify up to eight DNS
servers. To specify more than eight DNS servers, you must use the option 6 command to
define all DNS servers.
To customize a DHCP option in a DHCP address pool:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a DHCP address
pool and enter its view.
dhcp server ip-pool
pool-name
By default, no DHCP address pool
exists.
3. Customize a DHCP
option
code {
ascii
ascii-string |
hex
By default, no DHCP option is