HPE FlexNetwork MSR Series Comware 7 Layer 3 - Ip Services Configuration Guides

285
Step Command Remarks
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Specify a gateway address for
DHCPv6 clients.
ipv6 dhcp relay gateway
ipv6-address
By default, the DHCPv6 relay
agent uses the first IPv6
address of the relay interface as
the clients' gateway address.
Displaying and maintaining the DHCPv6 relay
agent
Execute display commands in any view and reset commands in user view.
Task Command
Display the DUID of the local device.
display ipv6 dhcp duid
Display DHCPv6 server addresses
specified on the DHCPv6 relay agent.
display ipv6 dhcp relay server-address
[
interface
interface-type interface-number ]
Display packet statistics on the DHCPv6
relay agent.
display ipv6 dhcp relay statistics
[
interface
interface-type
interface-number ]
Clear packets statistics on the DHCPv6
relay agent.
reset ipv6 dhcp relay statistics
[
interface
interface-type
interface-number ]
DHCPv6 relay agent configuration example
Network requirements
As shown in Figure 109, configure the DHCPv6 relay agent on Router A to relay DHCP packets
between DHCPv6 clients and the DHCPv6 server.
Router A acts as the gateway of network 1::/64. It sends RA messages to notify the hosts to obtain
IPv6 addresses and other configuration parameters through DHCPv6. For more information about
RA messages, see "Configuring basic IPv6 settings."
Figure 109 Network diagram

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English