306
Configuring IPv6 fast forwarding
Overview
Fast forwarding reduces route lookup time and improves packet forwarding efficiency by using a
high-speed cache and data-flow-based technology. It identifies a data flow by using the following
fields:
• Source IPv6 address.
• Destination IPv6 address.
• Source port number.
• Destination port number.
• Protocol number.
After a flow's first packet is forwarded through the routing table, fast forwarding creates an entry and
uses the entry to forward subsequent packets of the flow.
Command and hardware compatibility
Commands and descriptions for centralized devices apply to the following routers:
• MSR1002-4/1003-8S.
• MSR2003.
• MSR2004-24/2004-48.
• MSR3012/3024/3044/3064.
• MSR954(JH296A/JH297A/JH298A/JH299A/JH373A).
• MSR958(JH300A/JH301A).
Commands and descriptions for distributed devices apply to MSR4060 and MSR4080 routers.
Configuring the aging time for IPv6 fast forwarding
entries
The IPv6 fast forwarding table uses an aging timer for each forwarding entry. If an entry is not
updated before the timer expires, the device deletes the entry. If an entry has a hit within the aging
time, the aging timer restarts.
To configure the aging time for IPv6 fast forwarding entries:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Set the aging time for IPv6
fast forwarding entries.
ipv6 fast-forwarding
aging-time
aging-time
By default, the aging time is 30 seconds.
To Next Page
Loading...
Need help?
General
