HPE FlexNetwork MSR3012

152
Community name: userv1
Group name: testv1
Storage type: nonvolatile
Community name: cc
Group name: cc
ACL name: testacl
Storage type: nonVolatile
Table 31 Command output
Field
Description
Community name
Community name created by using the
snmp-agent community
command or
username created by using the
snmp-agent usm-user
{
v1
|
v2c
} command.
Group name
SNMP group name.
• If the community is created by using the snmp-agent community command in
VACM mode, the group name is the same as the community name.
• If the community is created by using the snmp-agent usm-user { v1 | v2c }
command, the name of the group that has the user is displayed.
Role name
User role name for the community.
If the community is created by using the
snmp-agent community
command in
RBAC mode, a user role can be bound to the community name.
ACL
Number of the ACL that controls the access of the NMSs in the community to the
device.
Only the NMSs with the IP addresses permitted in the ACL can access the device
with the community name.
This field appears
only when an SNMPv1 or SNMPv2c user is associated with an
ACL rule. It is exclusive with the
ACL name
field.
ACL name
Name of the ACL
that controls the access of the NMSs in the community to the
device.
Only the NMSs with the IP addresses permitted in the ACL can access the device
with the community name.
This field appears
only when an SNMPv1 or SNMPv2c user is associated with an
ACL rule. It is exclusive with the
ACL
field.
Storage type
Storage type:
• volatile—Settings are lost when the system reboots.
• nonVolatile—Settings remain after the system reboots.
• permanent—Settings remain after the system reboots and can be modified but
not deleted.
• readOnly—Settings remain after the system reboots and cannot be modified or
deleted.
• other—Any other storage type.
Context name
SNMP context:
•
If a mapping between an SNMP community and an SNMP context is configured,
the SNMP context is displayed.
• If no mapping between an SNMP community and an SNMP context exists, this
field is empty.
Related commands
snmp-agent community
snmp-agent usm-user { v1 | v2c }