HPE FlexNetwork MSR3012

186
snmp-agent target-host inform address udp-domain { ipv4-address | ipv6 ipv6-address }
[ udp-port port-number ] [ vpn-instance vpn-instance-name ] params securityname security-string
v3 { authentication | privacy }
snmp-agent target-host trap address udp-domain { ipv4-address | ipv6 ipv6-address } [ udp-port
port-number ] [ vpn-instance vpn-instance-name ] params securityname security-string v3
{ authentication | privacy }
undo snmp-agent target-host { trap | inform } address udp-domain { ipv4-address | ipv6
ipv6-address } params securityname security-string [ vpn-instance vpn-instance-name ]
Default
No SNMP notification target hosts exist.
Views
System view
Predefined user roles
network-admin
Parameters
inform: Sends notifications as informs.
trap: Sends notifications as traps.
address: Specifies the destination address of SNMP notifications.
udp-domain: Specifies UDP as the transport protocol.
ipv4-address: Specifies a target host by its IPv4 address or host name. The host name is a
case-insensitive string of 1 to 253 characters. The string can only contain letters, numbers, hyphens
(-), underscores (_), and dots (.). If you specify a host name, the IPv4 address of the target host can
be obtained.
ipv6 ipv6-address: Specifies a target host by its IPv6 address or host name. The host name is a
case-insensitive string of 1 to 253 characters, which only contains letters, numbers, hyphens (-),
underscores (_), and dots (.). If you specify a host name, the IPv6 address of the target host can be
obtained. If you specify an IPv6 address, the address cannot be a link local address.
udp-port port-number: Specifies the UDP port for SNMP notifications. If no UDP port is specified,
UDP port 162 is used.
vpn-instance vpn-instance-name: Specifies the VPN for the target host. The vpn-instance-name
argument specifies the name of the MPLS L3VPN, a case-sensitive string of 1 to 31 characters. If
this parameter is not specified, the target host is in the public network.
params securityname security-string: Specifies the authentication parameter. The security-string
argument specifies an SNMPv1 or SNMPv2c community name or an SNMPv3 username, a string of
1 to 32 characters.
v1: Specifies SNMPv1.
v2c: Specifies SNMPv2c.
v3: Specifies SNMPv3.
•
authentication: Specifies the security model to be authentication without privacy. You must
specify the authentication key when you create the SNMPv3 user.
•
privacy: Specifies the security model to be authentication with privacy. You must specify the
authentication key and privacy key when you create the SNMPv3 user.
Usage guidelines
You can specify a maximum of 20 SNMP notification target hosts.