HPE FlexNetwork MSR3012 User Manual

401
Default
No IPv6 NetStream aggregation mode is specified.
Views
System view
Predefined user roles
network-admin
Parameters
as: Specifies the AS aggregation by source AS number, destination AS number, input interface
index, and output interface index.
bgp-nexthop: Specifies the BGP nexthop aggregation by BGP next hop IPv6 address and output
interface index.
destination-prefix: Specifies the destination-prefix aggregation by destination AS number,
destination address mask length, destination prefix, and output interface index.
prefix: Specifies the source and destination prefix aggregation by the following criteria:
•
Source AS number.
•
Destination AS number.
•
Source address mask length.
•
Destination address mask length.
•
Source prefix.
•
Destination prefix.
•
Input interface index.
•
Output interface index.
protocol-port: Specifies the protocol-port aggregation by protocol number, source port, and
destination port.
source-prefix: Specifies the source-prefix aggregation by source AS number, source address mask
length, source prefix, and input interface index.
Usage guidelines
In IPv6 NetStream aggregation mode view, you can perform the following tasks:
•
Enable or disable the specified IPv6 NetStream aggregation mode.
•
Configure source interface, destination IPv6 address, and destination port for the IPv6
NetStream data export.
A flow matching multiple aggregation modes is counted as multiple aggregate flows.
Examples
# Set the IPv6 NetStream aggregation mode to AS, and enter IPv6 NetStream AS aggregation mode
view.
<Sysname> system-view
[Sysname] ipv6 netstream aggregation as
[Sysname-ns-aggregation-as]
Related commands
enable
ipv6 netstream export host
ipv6 netstream export source

HPE FlexNetwork MSR3012 Specifications

General

Brand	HPE
Model	FlexNetwork MSR3012
Category	Network Router
Language	English