4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Disconnect all peripheral cables from the server.
6. Remove the server from the rack .
7. Place the server on a flat, level work surface.
8. Remove the access panel.
9. Do one of the following:
a. Remove the air baffle.
b. Remove the midplane drive cage .
10. Remove the fan cage.
11. Remove the midwall bracket.
12. Remove the drive backplane bracket .
13. Disconnect the SATA-power Y-cable from the optical drive .
14. Disconnect the DisplayPort cable from the system board .
15. Remove the universal media bay:
a. Remove the universal media bay screws (callout 1).
b. Remove the universal media bay from the server (callout 2)
16. Remove the DisplayPort cable from the LFF universal media bay.
To Next Page
Loading...
