3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. Do one of the following:
a. Remove the air baffle.
b. Remove the midplane drive cage .
9. Disconnect the boot device signal and power cables from the system board .
10. Remove the secondary three-slot riser cage.
11. Disconnect the signal and power cables from the boot device.
12. Remove the boot device screws from the riser cage.
To Next Page
Loading...
