Huawei SmartLogger3000 - Page 101

Microgrid compatibility, Grid connection state, and Grid Code based on the
site requirements.
– In microgrid or o-grid scenarios, you are advised to set Microgrid
compatibility to Enable.
– In grid-tied scenarios, set Grid connection state to On-grid (PQ). In o-
grid
scenarios, set Grid connection state to O-grid (VSG).
Figure 6-19 Searching for devices
NO TE
▪ During the process of Search for Device, do not perform upgrade operations
(such as upgrading through the app, network management system, or
WebUI).
▪ When you click Search for Device, cable connections (DC and AC) will be
checked before device search (not applicable to third-party devices), and
device addresses will be automatically allocated.
▪ After the cable connection check and device search are complete, if a cable
connection alarm is generated, you can click the alarm icon
to view the
corresponding alarm information.
▪ If an alarm is generated when the cable connection check fails, click the
alarm icon to view the alarm cause and handling suggestions. After the
fault is rectied, check the cable connections again.
▪ After the cable connection check and device search are complete, click to
view the corresponding topology information.
▪
After a device is added or deleted, you need to click Search for Device again.
Otherwise, the system topology will not update.
3. Connect to power meters.
SmartLogger3000
User Manual 6 WebUI Operations
Issue 10 (2022-08-20) Copyright © Huawei Technologies Co., Ltd. 89