EasyManuals Logo
Home>Huawei>Data Loggers>SmartLogger3000

Huawei SmartLogger3000 User Manual

Huawei SmartLogger3000
305 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #264 background imageLoading...
Page #264 background image
Procedure
Step 1 Choose Maintenance > Device Mgmt. > Data Re-Collection.
Step 2 Select the type of the data to be collected and set the collection period.
Step 3 Select the name of the device whose data is to be collected and click Collect
Data.
Step 4 Wait until all data is gathered. On the Monitoring page, query the collection
result.
----End
7.4.10 Adjusting the Total Energy Yield
This section applies to V300R001C00.
Procedure
Step 1 Choose Maintenance > Device Mgmt. > Adjust total energy yield.
Step 2 Set Adjust total energy yield(kWh), select the name of the device whose total
energy yield needs to be adjusted, and click Submit.
----End
7.4.11 Force Start
This section does not apply to V300R001C00.
Procedure
Step 1 Choose Maintenance > Device Mgmt. > Force Start and click Starting up. This
operation will interrupt ongoing services in the array. Exercise caution when
performing this operation.
NO TE
The array-level force start operation lasts 180 minutes. The SmartLogger needs to
maintain the array-level force start state. The default status is Idle. After a force start
task is started, the SmartLogger periodically collects the SOC value of each battery rack.
If the SOC value is lower than 50%, the SmartLogger remains in the Force starting...
state. If the SOC value of each battery rack exceeds 50% or the maximum protection
duration for force start is exceeded, the SmartLogger restores the force start state to
Idle.
After a force start task is started, you can stop the task. In this scenario, devices in the
array stop force start and return to their original status.
After an array-level force start task is started, if new devices are connected and cannot
be automatically started or some devices restart, the SmartLogger delivers a force start
command at an interval of 5 minutes to ensure that the devices can identify the force
start state.
----End
7.5 Device Disposal
SmartLogger3000
User Manual 7 Device Maintenance
Issue 10 (2022-08-20) Copyright © Huawei Technologies Co., Ltd. 252

Table of Contents

Other manuals for Huawei SmartLogger3000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei SmartLogger3000 and is the answer not in the manual?

Huawei SmartLogger3000 Specifications

General IconGeneral
BrandHuawei
ModelSmartLogger3000
CategoryData Loggers
LanguageEnglish

Related product manuals