Huawei SmartLogger3000 - Commissioning Using Deployment Wizard (V300 R023 C00 and Later Versions)

Figure 6-17 Completing the conguration
----End
6.2.4 Commissioning Using Deployment Wizard
(V300R023C00 and Later Versions)
Context
The deployment wizard allows you to set basic SmartLogger parameters, connect
Huawei devices, power meters, and EMIs, congure energy storage control,
Huawei NMS, and third-part NMS, and implement interworking with third-party
devices.
After the SmartModule communicates with the SmartLogger properly, the
SmartLogger automatically
identies the SmartModule. The device name of the
SmartModule is Module(M1), and the corresponding port is M1. port.
Procedure
Step 1 Log in to the WebUI and access the deployment wizard page.
Step 2 Set parameters following the deployment wizard. For details, see Help on the
page.
NO TE
During parameter setting, click Previous, Next, or Skip as required.
1. Set basic parameters.
Figure 6-18 Setting basic parameters
2. After Huawei devices are connected, click Search for Device to check the
cable connections and allocate addresses. After searching for devices, set the
SmartLogger3000
User Manual 6 WebUI Operations
Issue 10 (2022-08-20) Copyright © Huawei Technologies Co., Ltd. 88