6.3.23 Smart Tracking Algorithm
Context
● Before using the smart tracking algorithm, check whether the plant meets the
requirements for using this function based on the onsite smart tracking
algorithm delivery checklist, and check whether the Modbus protocol versions
between the plant networking devices are compatible.
● The smart tracking algorithm can be congured only after a license is
purchased and loaded.
● For details about how to load a license, see 7.4.6 Managing Licenses.
Procedure
After the trackers are commissioned during onsite delivery, their parameters can
be intelligently controlled by the smart tracking algorithm.
1. Choose Settings > Smart Tracking Algorithm, set Tracker working mode to
Automatic and Smart tracking algorithm to Enable. Then, the smart
tracking algorithm automatically adjusts tracker parameters such as the angle
based on sunlight to maximize energy yield.
Figure 6-67 Smart tracking algorithm parameters
6.4 Setting Battery Control Parameters
This section does not apply to V300R001C00.
Procedure
Choose Settings > Battery control to set the battery working mode.
No Control
SmartLogger directly delivers the external scheduling power limit. No other power
scheduling control is performed. The power is automatically controlled by the
device.
Maximum Self-Consumption
● This mode applies to areas where the electricity price is high, or areas where
the FIT subsidy is low or unavailable.
● Excess energy is stored in batteries. When PV power is
insucient or no PV
power is generated at night, batteries discharge to supply power to the loads,
SmartLogger3000
User Manual 6 WebUI Operations
Issue 10 (2022-08-20) Copyright © Huawei Technologies Co., Ltd. 189
To Next Page
Loading...
Need help?
General
