● Method 1: When the SmartLogger connects to a Huawei or third-party
management system using the encrypted Modbus TCP protocol, set
management system parameters and click Submit.
After a Huawei NMS or a third-party NMS is connected to the SmartLogger in
Management System, another third-party NMS can be connected through
Management System-1 to obtain data from the SmartLogger and
congure the
SmartLogger.
Figure 6-30 Setting management system parameters
Table 6-2 Management System
Parameter
Description
Server Set this parameter to the IP address or domain name of
the Management System.
Port Set this parameter based on the connected Management
System.
Address mode The value can be Comm. Address or Logical address.
If the communications address of the device connected to
the SmartLogger is unique, you are advised to select
Comm. Address. In other cases, you must select Logical
address.
SSL encryption Retain the default value Enable.
NOTE
If this parameter is set to Disable, data exchange between the
SmartLogger and the management system will not be encrypted,
which poses security risks.
Second challenge
authentication
Set this parameter based on the connected management
system.
NOTE
If this parameter is set to Disable, the second challenge
authentication result is not checked, and user data may be stolen.
Therefore, exercise caution when setting this parameter.
Security certicate Optional. Set this parameter only when the certicate has
expired or the customer needs to use their own certicate.
SmartLogger3000
User Manual 6 WebUI Operations
Issue 10 (2022-08-20) Copyright © Huawei Technologies Co., Ltd. 97
To Next Page
Loading...
