Huawei SmartLogger3000 User Manual

Figure 6-37 Setting IEC104 parameters
Tab Parameter Description
Basic parameters Link setting IEC104 is a universal standard protocol
used to connect to a third-party
management system. Because there is
no security authentication mechanism,
data transmitted by IEC104 is not
encrypted. To reduce network security
risks, the function of connecting to a
third-party management system using
IEC104 is disabled by default. This
protocol can transmit the running data
and control commands of PV plants,
which may cause user data breach and
control permission theft. Therefore,
exercise caution when using this
protocol. Users are liable for any loss
caused by the use of this protocol to
connect to a third-party management
system (non-secure protocol). Users are
advised to take measures at the PV plant
level to reduce security risks, or use
Huawei management system to mitigate
the risks.
To use this function, set this parameter
to Enable(Limited) or
Enable(Unlimited).
● If this parameter is set to
Enable(Limited), the SmartLogger
can connect to a maximum of
ve
preset third-party management
systems.
● If this parameter is set to
Enable(Unlimited), the SmartLogger
can connect to a maximum of
ve
third-party management systems
with a valid IP address.
Public IP address
Set these parameters as required.
SmartLogger3000
User Manual 6 WebUI Operations
Issue 10 (2022-08-20) Copyright © Huawei Technologies Co., Ltd. 108

Huawei SmartLogger3000 Specifications

General

Brand	Huawei
Model	SmartLogger3000
Category	Data Loggers
Language	English