Huawei SmartLogger3000 - Page 282

Vendor Model Export Limitation
Socomec COUNTIS E43 Supported
NOTE
● Not applicable to single-phase power
scenarios.
● When the power meter connects to
the SmartLogger, an external 120–
ohm resistor needs to be connected to
the RS485 bus of the power meter. For
details, see the user manual of the
power meter.
Toshiba S2MS N/A
Wave Energy PWM-72 N/A
WEG MMW03-M22CH Supported
Table 8-2 Supported EMIs
Vendor Model EMI Information
ABB VSN800-12 Total irradiance, ambient
temperature, and PV
module temperature
VSN800-14 Total irradiance, ambient
temperature, PV module
temperature, wind
direction, and wind
speed
Gill MetPak Pro Gill MetPak Pro Total irradiance, ambient
temperature, PV module
temperature, wind
direction, and wind
speed
Hukseux SRx Hukseux SRx Total irradiance and
ambient temperature
Ingenieurbüro Si-
RS485TC
Ingenieurbüro Si-
RS485TC
Total irradiance, ambient
temperature, PV module
temperature, and wind
speed
Kipp&Zonen SMPx series Total irradiance and
ambient temperature
Lut WSx-UMB Total irradiance, ambient
temperature, wind
direction, and wind
speed
SmartLogger3000
User Manual 8 FAQ
Issue 10 (2022-08-20) Copyright © Huawei Technologies Co., Ltd. 270