Embellished Stitches – Menu N
Example of tassel stitch
Example of crystal stitch
Embellished stitches are decorative stitches where you can
change the appearance of the stitch after it is sewn for a
special effect. These stitches can be decorated with crystals
or cut for a tassel effect.
Tassel stitches are sewn with many threads on top of each
other. The threads can either be left as they are sewn or cut
to create a 3D effect. The long stitches should be cut at the
very edge and from the top side of the fabric. To make the
cutting easy, use a seam ripper.
Tip: For heavier threads, use the optional Specialty Candlewicking Foot
(part number 413 16 23-45) for easier feeding.
Crystal stitches could either be used as they are or be
embellished with crystals in the sewn circles.
Tapering Stitches – Menu Q
The tapering menu will be visible when a stitch that can be
tapered is selected. Touch the tapering menu to select from
different angles for beginning and end tapers. The machine
will sew the beginning tapered point and then continue with
the selected stitch. When the desired length has been sewn,
touch the reverse button. The stitch will taper to the end.
Select taper “off ” to remove any tapering at the beginning or
end of the stitch. If you select taper “off ” on both the
beginning and end, the stitch will be a regular stitch without
tapering.
100 7 Sewing
To Next Page
Loading...
