Sewing Pop-up Messages
Bobbin Thread Low
When the bobbin thread is running low, a pop-up message
appears giving you notice that you will soon need to change
the bobbin. This gives you an opportunity to plan when you
want to change your bobbin. If you want to continue sewing
without changing the bobbin, touch the foot control and do
not close the pop-up.
Check Upper Thread
The machine stops automatically if the upper thread runs out
or breaks. Re-thread the upper thread, close the pop-up
message and start sewing.
Remove Sensor One-Step Buttonhole Foot
The Sensor One-Step Buttonhole Foot is used only for
buttonholes. A pop-up message will advise you to remove
the foot for all other sewing.
Cannot Use the Automatic Needle Threader
If using a twin needle, touch OK and thread it manually. If
using a regular needle, touch OK and deselect twin needle in
the settings. Press the automatic needle threader button again.
Twin Needle
A pop-up message will appear when you choose a stitch not
suitable for twin needle.
Stitch Width Safety
When stitch width safety is activated, a pop-up message will
appear when you choose a stitch not suitable for stitch width
safety.
Attention!
If the machine stops and this pop-up appears on the screen
you need to stop sewing. Wait a moment and touch the OK
button when it is enabled. Check the needle size and
condition. Check for correct threading.
104 7 Sewing
To Next Page