Twin Needle
When a twin needle size is selected, the stitch width and
stitch position of all stitches are limited according to the
selected twin needle size to prevent damage to the needle,
presser foot and needle plate. In sewing mode the stitch
preview will indicate that a twin needle is selected. When a
twin needle size is selected, the stitch width safety will be
disabled as it cannot be used together with a twin needle.
Note: The settings are reset at the start of a new project from the
JoyOS ADVISOR™ feature. Always make sure to remove any
accessory that requires this setting or select the setting again after starting
a new project.
Feed Teeth Options
When auto is selected (recommended) your machine
automatically raises or lowers the feed teeth, depending on
the stitch and other selected settings. For example, the feed
teeth are lowered when sewing on buttons or when free
motion sewing.
Select up and the feed teeth will be raised for all sewing.
Select down and the feed teeth will be lowered for all sewing.
Note: Regardless of which option is selected the machine will always
lower the feed teeth automatically when raising the presser foot to extra
lift position.
Note: The feed teeth options will automatically be reset to auto at the
start of a new project from the JoyOS ADVISOR™ feature.
156 11 Settings
To Next Page